2010 · 10 citations · 7 references
EngineeringComputer EngineeringElectrical EngineeringLow-power DesignMicroelectronicsWireless CommunicationsDetector EfficiencyDetector TechnologyReceiver SystemsSemiconductor DetectorsUltra-wideband CommunicationDetector DesignGainImpulse Radio Ultra-widebandLow-power Amplifier DesignLow-power Cmos DesignReceiver SensitivitySub-threshold OperationUltra-wideband Receivers
A low power CMOS energy detector for 3.1-10.6 GHz non-coherent impulse-radio UWB receivers is implemented in a 0.13 μm CMOS process. The detector architecture is based on a squarer circuit realized with MOS transistors biased in the sub-threshold region. The squared signal is integrated using a low pass amplifier that allows the receiver gain to be optimized. A comparator with a tunable threshold is then used as a decision circuit. Experimental results show that a BER of 10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">-</sup> is achieved for a peak-to-peak voltage of 140 mV at the detector input at 200 Mb/s data rate. Assuming that the detector is driven by a LNA of gain 22 dB, leads to a receiver sensitivity of -45 dBm. The receiver dissipates only 25 mW, corresponding to an energy efficiency of 0.13 nJ/bit and the chip occupies 0.7 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> .
7
Bevin Perumana, R. Mukhopadhyay, Sudipto Chakraborty et al. · IEEE Journal of Solid-State Circuits · 2008 · 79 citations