SPE Reservoir Characterisation and Simulation Conference and Exhibition · 2011 · 11 citations · 4 references
EngineeringEarth SciencesPetroleum EngineeringPetrophysicsReservoir CharacterizationReservoir EngineeringCore AnalysisPermeability CharacterizationPetrophysical AnalysisPetrophysical EvaluationPorosity AnalysisReservoir HeterogeneityCarbonate Reservoir HeterogeneityCementation FactorCore PorosityPorosityPorosity From Core AnalysisReservoir Heterogeneity CharacterizationReservoir Heterogeneity EffectsSaturation Exponent
Reservoir heterogeneity is dependent upon depositional environments and subsequent events in the history of the reservoir. From a previous work, we reported variations in poroperms and cementation factor “m” as a function of different scale measurements and emphasized the importance of whole cores in better capturing reservoir heterogeneity. In the present work, we have extended our investigation on the effect of the multi-scale measurements on hundreds of samples from four different wells in a giant carbonate field in Abu Dhabi. Laboratory measurements were conducted on four different scale samples, ranging from full diameter 4 inch whole cores down to 1 inch plug samples. The smaller size samples were taken from the same bigger volume samples for direct comparisons. The multi-scale effect was studied on the variations of reservoir properties including porosity, permeability, capillary pressure and saturation exponent “n”. The multi-scale analyses confirmed the variations in rock properties and the influence of heterogeneity on reservoir performance. Whole core porosities tend to be lower than plug porosities. Permeability variations between different sample sizes appear to be governed by the degree of heterogeneity. Different capillary pressure and “n” curves were obtained from whole core and plug samples. The changes in rock properties as a function of sample scale (size) improve the understanding of reservoir heterogeneity and minimize the uncertainty in STOOIP calculations. INTRODUCTION Serag and co-workers [1] investigated the effect of multi scale measurements (whole cores down to small trims) on poroperm and cementation factor “m”. The samples came from single well “E” in the field, and the trims were taken from the plugs but the plug samples were cut adjacent to the whole cores. The main findings were that whole core porosity matched very well log data, and the plug porosities as compared to the whole core data were systematically higher. We found out that the degree of heterogeneity played a major role in comparing whole core to plug permeability. “m” was systematically reported lower in the measured whole core samples. The investigation has been extended to include hundreds of samples taken from 4 different wells in the same field. Laboratory measurements were conducted on full diameter four inch whole cores down to one inch diameter core plug samples. The smaller samples were taken from the same bigger volume samples for direct comparisons. The multi-scale effect was studied
4
Samy Serag El Din, Moustafa Dernaika, Ismail Al Hosani et al. · Abu Dhabi International Petroleum Exhibition and Conference · 2010 · 29 citations