Water film flow along fracture surfaces of porous rock

TLDR

The study isolated film flow effects by measuring hydraulic conductivity of Bishop Tuff blocks at near‑zero matric potentials, comparing results with and without wax‑sealed lateral sides. The experiments revealed that surface film flow on fracture surfaces is significant for matric potentials above –250 Pa, with film thicknesses of 2–70 µm and velocities 2–40 m d⁻¹—about a thousand times faster than pore water—thereby enhancing hydraulic conductivity, challenging aperture‑based flow predictions, and indicating that film flow is a key mechanism in unsaturated fracture and macropore flow.

Abstract

This study shows that hydraulic properties of individual fracture surfaces can be meaningfully defined and measured, and that water film flow is a mechanism contributing to fast, unsaturated flow in fractures. The hydraulic conductivity of an unconfined block of Bishop Tuff was measured over a range of near‐zero matric potentials, where differences between hydraulic conductivities obtained without and with wax sealing of its lateral sides allowed isolation of film flow effects. Tensiometer and flux measurements showed that surface film flow in this system was significant for matric potentials greater (more positive) than about −250 Pa. In this range the average film thickness was shown to be potential dependent and proportional to the observed enhanced hydraulic conductivity. Measured average surface film thicknesses ranged from 2 to 70 μm, with average film velocities in the range of 2 to 40 m d −1 (about 10 3 times faster than that of the pore water under unit gradient saturated flow). Our experiments demonstrate that hydraulic properties of macroscopic surfaces of porous media are quantifiable, related to surface roughness, and potentially important in the flow of water in vadose environments. This study further shows that contrary to existing conceptual models, unsaturated flow in fractures cannot generally be predicted solely on the basis of aperture distribution information. The high velocities of these surface films suggest that film flow can be an important mechanism contributing to fast flow in unsaturated fractures and macropores, especially in media characterized by low‐permeability matrix and along regions of convergent flow in partially saturated fractures.