GaN-based micro-LED arrays on flexible substrates for optical cochlear implants

Christian Goßler, Colin Bierbrauer, Rüdiger Moser, M. Kunzer, Katarzyna Holc, W. Pletschen, K. Köhler, J. Wagner, Michael Schwaerzle, Patrick Ruther,

Journal of Physics D Applied Physics · 2014 · 178 citations · 13 references

Concepts

TL;DR

Current cochlear implants rely on electrical stimulation, while optical micro‑LED arrays promise higher frequency resolution. The study reports the development of a flexible GaN‑based micro‑LED array for use as an optical cochlear implant in a mouse model. The array is fabricated by laser‑assisted layer transfer of GaN‑LEDs from sapphire to a polyimide‑on‑silicon carrier, producing 15‑µm‑thin, 50×50‑µm² LEDs with conductive contacts on both sides, which are then peeled and mounted on flexible PCBs. The implantable probes, each containing four µLEDs, were successfully inserted into mouse cochleae and could address up to three independent channels, emitting 60 µW at 1 mA (6 mW mm⁻²) after peel‑off.

Abstract

Currently available cochlear implants are based on electrical stimulation of the spiral ganglion neurons. Optical stimulation with arrays of micro-sized light-emitting diodes (µLEDs) promises to increase the number of distinguishable frequencies. Here, the development of a flexible GaN-based micro-LED array as an optical cochlear implant is reported for application in a mouse model. The fabrication of 15 µm thin and highly flexible devices is enabled by a laser-based layer transfer process of the GaN-LEDs from sapphire to a polyimide-on-silicon carrier wafer. The fabricated 50 × 50 µm2 LEDs are contacted via conducting paths on both p- and n-sides of the LEDs. Up to three separate channels could be addressed. The probes, composed of a linear array of the said µLEDs bonded to the flexible polyimide substrate, are peeled off the carrier wafer and attached to flexible printed circuit boards. Probes with four µLEDs and a width of 230 µm are successfully implanted in the mouse cochlea both in vitro and in vivo. The LEDs emit 60 µW at 1 mA after peel-off, corresponding to a radiant emittance of 6 mW mm−2.

References

13