Chemical Modification of Metal Oxide Surfaces in Supercritical CO<sub>2</sub>:  The Interaction of Supercritical CO<sub>2</sub> with the Adsorbed Water Layer and the Surface Hydroxyl Groups of a Silica Surface

Carl P. Tripp, J. R. Combes

Langmuir · 1998 · 95 citations · 18 references

Concepts

Abstract

Infrared spectroscopy was used to probe the interaction of CO 2 under supercritical fluid (SCF) conditions with a fumed silica. The experimental difficulties associated with CO 2 absorption of infrared light in the hydroxyl spectral region are overcome by using deuterated silica or by venting of the CO 2 prior to obtaining a spectrum. It is shown that CO 2 behaves quite differently from traditional nonaqueous solvents (i.e., carbon tetrachloride, toluene, and cyclohexane) with respect to interactions with the adsorbed layer of water on the surface. A dry silica easily extracts and adsorbs the residual water present in these nonaqueous solvents whereas, in contrast, a dry silica remains dry when placed in contact with the SCF CO 2 . Moreover, the CO 2 extracts the adsorbed water from wet silica. The SCF solvent extracts more surface water into the fluid phase with increasing density, and repeated extraction cycles with SCF CO 2 result in the removal of all water from the surface. The interaction of SCF CO 2 with the hydroxyl groups was studied using deuterated silica. Using a dry or wet deuterated silica, the physisorption of CO 2 with the isolated SiOD groups is shown to be weak in nature and of the same magnitude as that measured in CCl 4 . The SiOD band at 2762 cm - 1 is completely shifted to 2710 cm - 1 at relatively low pressures of CO 2 (5 bar) and remains shifted with increasing amounts of CO 2 up to the highest pressures studied (200 bar).

References

18