Distortions and Residual Stresses of Gears Caused by Hardening : 4th Report, Case-Hardening of Gears

Hiroshige FUJIO, Toshio Aida, J. Akizono

Bulletin of JSME · 1979 · 10 citations · 0 references

DOIFull text

Open access

Concepts

Abstract

Distortions of case-hardened gears were calculated using the method introduced by the authors, and the results were compared with experimental ones. The results obtained in this paper are summarized as follows. (1) For case-hardening, gear distortions can be calculated tolerably well from the estimation of quenched structure. (2) In this investigation, the quenched structure of SCM21 after case-hardening in the carburizing layer was mostly martensite, and the value of thermal expansion coefficient for each carbon content could be determined by the depth from surface of tooth profile. (3) In this experiment, retained austenite was scarcely observed. But, in the case of much retained austenite, the effect of retained austenite on distortion of gear tooth profile and residual stress should not be ignored.