Materials and Manufacturing Processes · 2014 · 10 citations · 24 references
EngineeringMaterials EngineeringMaterials ScienceMaterials ProcessingMetallic MaterialsTribologyCoatingsMachiningMetalsMetalworking TechnologySurface CoatingsTribological MaterialsAluminium AlloysChemical DegradationChemical Degradation Of SurfacesCoating Effects On FrictionCoating TribologyHumidityLubricationMachining Processes
In the present paper, a graphite–PTFE composite coating (Gr-x) on an HSS end mill is proposed for machining aluminium. The suitability of this coating was first simulated in a pin-on-disc test and was compared to the performance of MoS2 before evaluation through machining testing. In the tribo-test, both coatings exhibited their extraordinary lubrication properties and could successfully reduce uneven frictional forces as observed with an aluminium pin against uncoated HSS. However, MoS2-coated HSS end mills failed to produce such a favorable impact in machining. SEM images and chip morphology indicate evidence of the adherence of aluminium on the rake surface of a MoS2-coated tool. In contrast, Gr-x coating substantially outperformed MoS2 in the end milling test. Built-up edge (BUE) was completely arrested by Gr-x coating, and a better finish resulted from reduction of cutting force. Under the given machining conditions, the temperature was expectedly below the chemical degradation point of both coating materials and hence environmental humidity seemed to be a critical factor, which weakened the performance of MoS2 but improved that of graphite. Cutting speeds no higher than 60 m/min are recommended for Gr-x coating during end milling of aluminium.
24
Fritz Klocke, Gerrit Eisenblätter · CIRP Annals · 1997 · 737 citations
Robert H. Savage · Journal of Applied Physics · 1948 · 441 citations
Natural Sciences, Materials Engineering, Materials Science +17