Analyzing poly(3-hexyl-thiophene):1-(3-methoxy-carbonyl)propyl-1-phenyl-(6,6)C61 bulk-heterojunction solar cells by UV-visible spectroscopy and optical simulations

Kristian O. Sylvester‐Hvid, Tobias Ziegler, Moritz Riede, Nicholas Keegan, Michael Niggemann, Andreas Gombert

Journal of Applied Physics · 2007 · 24 citations · 31 references

Concepts

Abstract

A nondestructive method for assessing the thickness of the photoactive layer in poly(3-hexyl-thiophene):1-(3-methoxy-carbonyl)propyl-1-phenyl-(6,6)C61 (P3HT:PCBM) solar cells is reported. In the approach the absorption spectrum of the solar cell as derived by optical simulations is fitted to the corresponding measured spectrum, varying only the P3HT:PCBM layer thickness. Within the 50–250nm thickness range, a linear correlation between the position of a certain spectral minimum and the P3HT:PCBM layer thickness is shown, based on simulated absorption spectra. As an initial application, absorption spectra for 240 P3HT:PCBM solar cells prepared at four different spin-coating speeds were recorded, and the average P3HT:PCBM layer thickness estimated for each spin-coating speed. The simulated fraction of light absorbed in the P3HT:PCBM layer of the solar cells is compared with the P3HT:PCBM absorption spectra measured for films spin coated on simpler substrate types. The latter spectra cannot account for the light harvested in the photoactive layer of P3HT:PCBM solar cells because of substantial optical interference in the solar cells. The measured short circuit current densities Jsc for the solar cells vary with the spin-coating speed in a manner confirmed by optical simulations of the maximal short circuit current densities. The measured efficiencies follow the same pattern. On average the measured Jsc is 1–2mA∕cm2 below the simulated maximal short circuit current densities. Based on the resemblance of the measured and simulated absorption spectra such difference can be attributed to recombination exclusively.

References

31