Sand Transport in Nile River, Egypt

Abstract

Measurements of bed-load and suspended-load transport rates were carried out successfully at four cross sections of the Nile River, in Egypt, along the entire length from Aswan to Cairo using a mechanical sampler called the Delft Nile Sampler. The measured transport rates were compared to similar data sets from two other large scale rivers: the Rhine-Waal River in the Netherlands and the Mississippi River in the USA. The bed-load transport rates in the Nile River and in the Rhine-Waal River are in very good agreement. Comparison of suspended transport rates in the Nile River and in the Mississippi River shows that both data sets are complementary, revealing a very consistent trend of suspended transport against current velocity; suspended transport is roughly proportional to (Vav)3to4. Three formulas for the prediction of bed-load transport were tested using the Nile data: Meyer-Peter–Muller, Bagnold, and Van Rijn. The prediction formula of Van Rijn produced significantly better results than the other two formulas; the average relative error was about 60%. The formula of Van Rijn was modified to extend it to conditions with slightly nonuniform sediment mixtures by introducing a correction factor for the bed shear parameter. Based on a limited number of flume experiments, the correction factor was found to be dependent on the characteristics of the sediment mixture (d10,d50,d90, and σg). Comparison of bed-load transport measured in the Nile River with computed transport rates of the modified formula showed improved results; the average relative error decreased to about 30%. The formulas of Bagnold and Van Rijn were also used to compute the suspended transport rates in the Nile River. The computed transport rates were found to be within a factor of 2 of measured values; the formula of Bagnold performed slightly better. The total load transport formula of Engelund–Hansen was also successfully used (computed values within a factor of about 2 of measured values).