IEEE Photonics Technology Letters · 2006 · 38 citations · 9 references
EngineeringElectrical EngineeringMaterials ScienceOpticsOptoelectronicsPhotonicsLaser OpticsLaser PhysicsOptical ResonatorsOptical SourcesSemiconductor LasersCavity DesignExternal-cavity LasersIntegrated LasersMaximum OutputMaximum Power OutputPower Output OptimizationThermal ConductivityVertical-cavity Surface-emitting Lasers
We report on the operation and beam profile analysis of an optically pumped GaSb-based vertical-external-cavity surface-emitting laser at 2.33 μm. To compensate for the low thermal conductivity of the laser chip, an intracavity heat spreader made from polycrystalline chemical vapor deposition diamond was bonded to the top surface of the chip. In this configuration, at -18/spl deg/C, a maximum continuous-wave output power of 0.6 W in a multitransverse mode beam (M <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> /spl ap/2.7) was achieved, limited by the available pump power. Optimizing the resonator for TEM/sub 00/ laser emission (M <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> /spl ap/1.1), an output power exceeding 0.4 W was observed at the same temperature.
9
Semiconductor wafer bonding via liquid capillarity
Z. L. Liau · Applied Physics Letters · 2000 · 200 citations
8-W high-efficiency continuous-wave semiconductor disk laser at 1000 nm
S. Lutgen, T. Albrecht, P. Brick et al. · Applied Physics Letters · 2003 · 141 citations