Materials and Manufacturing Processes · 2014 · 140 citations · 20 references
EngineeringMaterials EngineeringMaterials ScienceManufacturing ProcessesMaterials ProcessingSurface EngineeringComposite MaterialsDielectric CeramicsMachiningMicrostructure ControlPowder ProcessingMachining ProcessesMachining TechnologyMaterial Removal EffectsMaterial Removal ModelingProcess ParametersProcess Parameters OptimizationSurface Finish EnhancementSurface Finish Formation
In the present work, aluminum alloy 6061/10%SiC composite is machined using numerical controlled Z-axis (ZNC) electrical discharge machining (EDM) process. Improvement in material removal rate (MRR) is explored using tungsten powder suspended dielectric fluid in EDM process (powder-mixed electrical discharge machining (PMEDM)). Peak current, pulse on time, pulse off time, and gap voltage are studied as process parameters. Mathematical relation between process parameters and MRR is established on basis of response surface methodology. The results obtained are further compared with MRR achieved from machining using simple EDM. The existence of tungsten particles in kerosene resulted in 48.43% improvement in MRR. The influence of tungsten powder-mixed dielectric fluid on machined surface is analyzed using scanning electron microscope and energy dispersive spectroscopy (EDS). The results revealed improvement in surface finish and reduction in recast layer thickness with PMEDM. EDS analysis reported presence of tungsten and carbon in recast layer deposited on machined surface.
20
Aluminium matrix composites: Challenges and opportunities
M.K. Surappa · Sadhana · 2003 · 1.2K citations
Natural Sciences, Materials Engineering, Materials Science +12