SPE Enhanced Oil Recovery Symposium · 1986 · 47 citations · 9 references
EngineeringEarth SciencesPetroleum EngineeringPetrophysicsReservoir CharacterizationReservoir SimulationPetrophysical AnalysisPore Structure AnalysisPorosity AnalysisPorosity CharacterizationPorosity EvaluationPorous MaterialsPore System CharacterizationSingle-well TestingTracer Test InterpretationTracer TestingTracer Tests
Abstract About 22 single-well chemical tracer tests have been performed in carbonate formations since 1971, to determine residual oil saturation after water flooding. The results in almost every case have been very different from equivalent tests run in sandstone reservoirs. The tracer profiles observed in carbonate tests show a set of characteristic distortions. Among these are poor apparent material balance; excessive early dilution of tracers; early arrival of poorly defined peaks for tracers that were displaced away from the well during injection; and abnormally large mean retention volumes, caused by extended concentration tails. A modified form of the "dead-end" pore model has been shown to reproduce all of these features. The various parameters examined in the model relate to the fraction of the pore space which is non-flowing, connected to the flowing fraction only by diffusion paths. Diffusion of each tracer in the non-flowing pore fraction is a function of tracer distribution coefficient; mixing length in the flowing fraction, equivalent to the usual dispersion parameter; and the residual oil saturation in both pore fractions. This model has been used to simulate single-well tracer tests in west Texas dolomites, Canadian reefs, and other carbonate formations. The best-fit values of non-flowing fraction of pore space have been 0.40–0.75. The observed diffusion effects, which are a ratio of test duration to the characteristic time of diffusion of tracer in the non-flowing pores, varies from less than 0.5 to more than 5, depending on the test. In the higher range of the diffusion parameter, the tracer profiles approach ideal shape. This indicates that the distribution of tracer between the two pore fractions is near equilibrium. For low values of the diffusion parameter, the profiles are extremely distorted. Slow diffusion limits the access of the tracers to the non-flowing fraction of the pore space.
9
Dead-End Pore Volume and Dispersion in Porous Media
K.H. Coats, B.D. Smith · Society of Petroleum Engineers Journal · 1964 · 1.1K citations · Full text
Single-Well Tracer Method To Measure Residual Oil Saturation
J. F. Tomich, R.L. Dalton, H. A. Deans et al. · Journal of Petroleum Technology · 1973 · 190 citations