Machining Science and Technology · 2010 · 73 citations · 33 references
EngineeringManufacturing EngineeringMechanical EngineeringManufacturing ProcessesMaterials ProcessingThermal AnalysisMachiningMetalworking TechnologySurface RoughnessTool SteelsWear-resistant MaterialsCold-work Tool SteelsCutting ForcesCutting WearRoughnessSurface Roughness ParametersTool WearTurningWear Evolution
Long-term wear tests on the CBN tool behaviour during hard turning of AISI D3 (60 HRC) have been investigated. The evolution of surface roughness, cutting forces and temperature has been studied according to the cutting parameters and tool wear. Results show that CBN is resistant to wear despite of aggressiveness of AISI D3 steel. A great part of heat generated is mainly dissipated throughout the chip; at a cutting speed of 320 m/min the chip temperature is found to be 14 times higher than that recorded in the workpiece. The cutting speed range of 90 to 240 m/min has been found suitable to cut this material. The former speed range is appropriate to respect the cutting constraints, whereas beyond 240 m/min a drastic increase in tool wear occurs, causing a remarkable drop in tool life. Roughness measurements reveal a dependence on CBN tool wear. However, although the wear rises up to the allowable flank wear of value 0.3 mm, roughness Ra remains around 1.0 μm. The feed rate remains the most affecting factor on the roughness values. The proposed statistical models are based on the response surface methodology correlating the cutting parameters together with roughness, cutting forces and tool life.
33
M.Y. Noordin, V.C. Venkatesh, Safian Sharif et al. · Journal of Materials Processing Technology · 2003 · 738 citations
Tugrul O ̈zel, Tsu-Kong Hsu, Erol Zeren · The International Journal of Advanced Manufacturing Technology · 2004 · 373 citations
Engineering, Manufacturing Engineering, Materials Science +17