ACS Applied Materials & Interfaces · 2014 · 149 citations · 19 references
Natural SciencesMaterials EngineeringMaterials ScienceElectronic MaterialsMetallic MaterialsMetallurgyConductive MaterialsElectrical ConductivityPrinting TechniquesSinteringEnergyInsulating MaterialsIrradiation EffectsProductivityPulse Duration EffectsResistivity
We demonstrate intense pulsed light (IPL) sintering of inkjet-printed CuO layers on a primer-coated porous PET substrate to convert the electrically insulating CuO into conductive Cu. With this approach, conductive layers are obtained in less than 1 s after the printing process. The IPL sintering was performed for high productivity with minimum duration and repetition of IPL irradiation to evaluate the effect of pulse number and energy output on the conductivity and morphology of the sintered Cu layers. Depending on the energy output, sheet resistances were measured as 0.355, 0.131, and 0.121 Ω·□(-1) by exposure energy of 5.48 (single pulse), 7.03 (double pulse), and 7.48 J·cm(-2) (triple pulse), respectively. In contrast, an excessive energy with relatively short pulse duration causes a delamination of the Cu layer. The lowest resistivity of about 55.4 nΩ·m (corresponds to about 30% conductivity of bulk Cu) was obtained by an IPL sintering process of 0.26 s after the printing, which was composed of 2 ms triple pulses with 10 Hz frequency.
19
Capillary flow as the cause of ring stains from dried liquid drops
Robert D. Deegan, Olgica Bakajin, Todd F. Dupont et al. · Nature · 1997 · 6.3K citations
Intense pulsed light sintering of copper nanoink for printed electronics
Hak‐Sung Kim, Sanjay R. Dhage, Dong-Eun Shim et al. · Applied Physics A · 2009 · 435 citations · Full text
Natural Sciences, Materials Engineering, Materials Science +14