Characterization of the Early-Time Mechanical Behavior of Well Cements Employed in Surface Casing Operations

Dan Mueller, Ramy Eid

2006 · 13 citations · 5 references

Concepts

Abstract

Abstract Pressure events that occur after surface casing cementation, such as casing integrity testing, formation integrity testing, etc. all impose stress upon the recently set cement sheath. The magnitude of stress will depend on the pressure state, casing thickness, cement sheath thickness and mechanical parameters of the cement and formation. Should pressure testing take place during the early stages of cement curing, the tangential stress imposed by the pressure event can exceed the tensile strength of the cement, thereby inducing cement sheath failure. It is well documented that cement is much stronger in compression than in tension. In most wellbore pressure scenarios, cement fails in tension. The proportionality between the compressive strength and the tensile strength of set cement is generally assumed to be an 8:1 to 10:1 ratio. During typical pressure testing events, the cement will have a compressive strength ranging from the 500 psi required for the commencement of drilling operations to upwards of 2000 psi depending on the cement curing time. Accordingly, conventional wisdom would hold that the tensile strength of the cement would be in the range of 50 to 200 psi at the time of casing pressure testing. However, accurate prediction of the degree of pressure induced cement sheath stress requires more than a general correlation to derive cement tensile strength. This paper characterizes the early-state physical properties and mechanical behavior of accelerated API Class A, G, H and ASTM Type I cement designs during the twelve hours following placement. The confined/unconfined compressive strengths, ultrasonic compressive strengths, tensile strengths, Young's Modulus and Poisson's Ratio of four commonly used "tail" cements as a function of time are presented. Predictions of induced stress in typical casing/hole size combinations as functions of pressure are also included. The results from this testing provides guidance as to when pressure testing of the casing/formation can take place without inducing damage to the set cement sheath.

References

5