Correction Method for RS80-A Humicap Humidity Profiles and Their Validation by Lidar Backscattering Profiles in Tropical Cirrus Clouds

Abstract

Abstract Routine radiosonde relative humidity (RH) measurements are not reliable as they are presently used in the global upper-air network. The new Lindenberg measuring and evaluation method, which provides RH profile measurements with an accuracy of ±1% RΗ in the temperature range from 35° to −70°C near the tropical tropopause is described. This Standardized Frequencies (FN) method uses a thin-film capacitive polymer sensor of a modified RS90-H Humicap radiosonde. These research humidity reference radiosondes (FN sondes) are used to develop a correction method for operational RS80-A Humicap humidity profiles. All steps of correction and quality control for RS80-A radiosondes are shown: ground-check correction, time-lag and temperature-dependent correction, and the recognition of icing during the ascent. The results of a statistical comparison between FN sondes and RS80-A sondes are presented. Corrected humidity data of operational RS80-A sondes used in Lindenberg (4 times daily) show no bias when compared to FN radiosondes and have an uncertainty of about ±3% RH at the 1 σ or 68% confidence level from 1000 to about 150 hPa. Only a small dry bias of at most −2% RH remains in the lowest part of the boundary layer (up to 500-m height). Finally, some examples of corrected RS80-A RH profiles in cirrus clouds validated by lidar backscattering profiles in a region of the intertropical convergence (Maldive Islands) are demonstrated. The soundings indicate that ice-saturated and ice-supersaturated air above 10-km height were connected with cirrus clouds in all 47 investigated cases, and, second, that the corrected RS80-A RH profiles also provide good quality information on water vapor in the upper troposphere.