Foot & Ankle International · 2004 · 63 citations · 64 references
MedicineOrthopaedic SurgeryOrthopedic SurgeryJoint Replacement SurgeryOrthopedic BiomechanicsOrthopedicsAnkle ArthroplastyAnkle OrthopedicsAnkle SurgeryArthroplasty BiomechanicsKnee ArthroplastyAnkle Joint ArthroplastyAnkle Prosthesis DesignMechanical Support For BonePolyethylenePolyethylene ImplantsTotal Joint Arthroplasty
In the past, total ankle arthroplasty was largely abandoned due to poor survivorship most often caused by loss of bone support. High complication rates were also reported. Despite this, there is renewed interest in ankle arthroplasty and encouraging results are seen in survivorship with midterm follow-up. The procedure, however, remains more challenging than total hip or total knee arthroplasty. With the limited soft tissue envelope, wound problems are not uncommon. Forces at the ankle are very large and yet the surface area for prosthetic support is small. Therefore, fixation can be more difficult. The strongest bone can be eccentric at the distal tibia. The tibial prosthesis can, therefore, tend to settle into the softer bone often laterally. Polyethylene needs to be sufficiently thick to maintain its integrity but that requires a larger bone resection, which weakens bone support. Polyethylene failure or wear leads to the majority of failures in hip and knee arthroplasty. There is a need for further basic science research in total ankle arthroplasty. The lessons learned from other arthroplasty should be considered in ankle arthroplasty design.
64
P. L. R. Wood, Susan Deakin · Journal of Bone and Joint Surgery - British Volume · 2003 · 569 citations
Michael Pyevich, Charles L. Saltzman, John J. Callaghan et al. · Journal of Bone and Joint Surgery · 1998 · 400 citations