21:T49c,In addition to superhydrophobicity/superoleophobicity, surfaces with switchable water/oil repellency have also aroused considerable attention because of their potential values in microreactors, sensors, and microfluidics. Nevertheless, almost all those as-prepared surfaces are only applicable for liquids with higher surface tension (γ > 25.0 mN m^-1) in air. In this work, inspired by some natural models, such as lotus leaf, springtail skin, and filefish skin, switchable repellency for liquids (γ = 12.0-72.8 mN m^-1) in both air and liquid is realized via employing 3D deformable multiply re-entrant microstructures. Herein, the microstructures are fabricated by a two-photon polymerization based 3D printing technique and the reversible deformation is elaborately tuned by evaporation-induced bending and immersion-induced fast recovery (within 30 s). Based on 3D controlled microstructural architectures, this work offers an insightful explanation of repellency/penetration behavior at any three-phase interface and starts some novel ideas for manipulating opposite repellency by designing/fabricating stimuli-responsive microstructures.22:T4b4,Two-photon lithography (TPL) is a powerful tool to construct small-scale objects with complex and precise 3D architectures. While the limited selection of chemical functionalities on the printed structures has restricted the application of this method in fabricating functional objects and devices, this study presents a facile, efficient, and extensively applicable method to functionalize the surfaces of the objects printed by TPL. TPL-printed objects, regardless of their compositions, can be efficiently functionalized by combining trichlorovinylsilane treatment and thiol-ene chemistry. Various functionalities can be introduced on the printed objects, without affecting their micro-nano topographies. Hence, microstructures with diverse functions can be generated using non-functional photoresists. Compared to existed strategies, this method is fast, highly efficient, and non photoresist-dependent. In addition, this method can be applied to various materials, such as metals, metal oxides, and plastics that can be potentially utilized in TPL or other 3D printing technologies. The applications of this method on the biofunctionalization of microrobots and cell scaffolds are also demonstrated.23:T434,Photonic crystal hydrogels (PCHs), with smart stimulus-responsive abilities, have been widely exploited as colorimetric sensors for years. However, the current fabrication technologies are mostly applicable to produce PCHs with simple geometries at the sub-millimeter scale, limiting the introduction of structural design into PCH sensors as well as the accompanied advanced applications. This paper reports the microfabrication of three-dimensional (3D) PCHs with the help of supramolecular agarose PCH as a sacrificial scaffold by two-photon lithography (TPL). The supramolecular PCHs, formulated with SiO₂ colloidal nanoparticles and agarose aqueous solutions, show bright structural color and are degradable upon short-time dimethyl sulfoxide treatment. Leveraging the supramolecular PCH as a sacrificial scaffold, PCHs with precise 3D geometries can be fabricated in an economical and efficient way. This work demonstrates the application of such a strategy in the creation of structural-designed PCH mechanical microsensors that have not been explored before.

	Year	Citations

About