Improvement of mechanical properties of a cryorolled Al-Mg-Si alloy through warm rolling and aging

L. Mei, X.P. Chen, Guangjie Huang, +1

Journal of Alloys and Compounds

Materials ScienceEngineeringMechanical PropertiesMechanical EngineeringAlloy Design +7

Studies on the evolution of annealing twins during recrystallization and grain growth in highly rolled pure nickel

X.P. Chen, Lifeng Li, Hua Sun, +2

Materials Science and Engineering A

Materials ScienceMaterials EngineeringEngineeringSevere Plastic DeformationGrain Growth +8

Precipitation transformation pathway and mechanical behavior of nanoprecipitation strengthened Fe–Mn–Al–C–Ni austenitic low-density steel

Y.F. An, X.P. Chen, L. Mei, +2

Journal of Material Science and Technology

Materials ScienceMaterials EngineeringMagnetic PropertiesEngineeringMechanical Behavior +5

Intragranular brittle precipitates improve strain hardening capability of Fe–30Mn–11Al–1.2C low-density steel

Peng Ren, X.P. Chen, L. Mei, +3

Materials Science and Engineering A

Materials ScienceEngineeringMechanical EngineeringIntragranular Brittle PrecipitatesStrain Hardening Capability +5

Ultrastrong and ductile austenitic lightweight steel via ultra-fine grains and heterogeneous B2 precipitates

Y.F. An, X.P. Chen, Peng Ren, +1

Materials Science and Engineering A

Materials EngineeringUltra-fine GrainsMaterials ScienceEngineeringHeterogeneous B2 Precipitates +4

Effect of warm deformation on precipitation and mechanical properties of a cryorolled Al-Zn-Mg-Cu sheet

L. Mei, X.P. Chen, Peng Ren, +3

Materials Science and Engineering A

Materials ScienceMaterials EngineeringWarm DeformationEngineeringMechanical Properties +9

Precipitate evolution and properties of an Al–Zn–Mg–Cu alloy processed by thermomechanical treatment

L. Mei, Mingjun Yang, X.P. Chen, +3

Materials Science and Engineering A

Materials ScienceMaterials EngineeringEngineeringMechanical EngineeringAlloy Design +8

Influence of rolling ways on microstructure and anisotropy of AZ31 alloy sheet

X.P. Chen, Shang Du, Rui Xiao, +2

Transactions of Nonferrous Metals Society of China

Materials ScienceEngineeringMechanical EngineeringAz31 Alloy SheetAlloy Design +5

Good combination of strength and corrosion resistance in an Al-Cu-Mg alloy processed by a short-cycled thermomechanical treatment

L. Mei, X.P. Chen, Chao Wang, +2

Materials Characterization

Materials ScienceEngineeringCorrosionMechanical EngineeringAl-cu-mg Alloy +4

Enhancing strength-ductility balance in Fe-Mn-Al-C-Ni austenitic low-density steel via intragranular dual-nanoprecipitation

Y.F. An, X.P. Chen, L. Mei, +3

Journal of Material Science and Technology