llite formation, isothermal treatments between 300°C and 1600°C were performed, keeping the samples at each temperature during 4 h. From XRD results, it may be said that precursor powders originally amorphous start to crystallize in Al 2 O 3 and SiO 2 at 1200°C, and the mullite formation starts at 1200°C, with being completed at 1600°C. The use of TSBAI favors the formation of mullite crystals at lower temperature. From SEM observations a microstructure that presents primary mullite with randomly oriented grains of secondary mullite with acicular shapes and sizes that range between 1.25 and 1.50 μm long may be determined.25:T4d0,The heat transfer from a fluidized bed to the cooling jacket of the vessel has been studied for various powders at minimum fluidization conditions, by both convection and conduction approaches. These heat transfer characteristics are important as the point of transition between packed and fluidized bed operations and are needed in designing heat transfer operations where bubble-flow is not permitted. The effective thermal conductivity of the emulsion moreover determines the contact resistance at the heating or cooling surface, as used in packet renewal models to predict the wall-to-bed heat transfer. In expressing the overall heat transfer phenomenon as a convective heat transfer coefficient, it was found that the results could be fitted by Numf,j=0.01Ar0.42.26:T4d0,Material feeding and handling systems have been cited as one of the most common causes of process downtime where thermochemical conversion processes are concerned. New and emerging fuels come in a variety of forms, and if such fuels are to be deployed widely it is imperative that material feeding and handling systems are designed appropriately. This study proposes an approach for designing material feeding and handling systems for use with coarse solid fuels. The data obtained from this study indicates particle size to be one of the key issues affecting the flowability of bulk solids further to the uniformity in particle shape. Coarse bulk solid samples were shown to flow more freely than their milled and pulverised counterparts, generating higher degrees of flowability. The results from this study were also applied to a new feed system used for feeding solid fuels to high pressure processes named the Hydraulic Lock Hopper. In this study the Hydraulic Lock Hopper demonstrated the feeding of wood pellets, torrefied spruce pellets, and ground anthracite coal grains against a pressure of 25 barg in two modes of operation. Energy savings compared to conventional lock hopper systems were recorded in the region of 80%.27:T587,

#	Concept	H-Index	Publications	Citations
1	Engineering	9	9	338
2	Biomedical Engineering	2	2	86
3	Medicine	1	1	51
4	Applied Physics	1	1	10
5	Chemical Engineering	1	1	10

	Year	Citations

About

Top Concepts