Glyceryl monostearate as a glidant in aqueous film-coating formulations

Hans Ulrich Petereit, Manfred Assmus, Klaus Lehmann

European Journal of Pharmaceutics and Biopharmaceutics · 1995 · 24 citations · 0 references

Concepts

Abstract

Aqueous spraying suspensions with poly(meth)acrylate dispersions need the addition of glidants in order to reduce the sticking of cores during the coating process. Glycerol monostearates (GMS) turned out to be an excellent alternative to talc or magnesium stearate. Placebo tablets, theophylline granules and pellets as well as acetylsalicylic acid and potassium chloride crystals were used to demonstrate the drug-release properties of GMS and its effects on the coatings. Controlled drug release was achieved by application of Eudragit® L 30 D-55, NE 30 D, RL 30 D and RS 30 D. Because of the high efficacy of GMS, only low amounts of 2 to 15% (based on dry polymer) are necessary. The glidant must be dispersed in water separately to produce a suspension with 2% solids. An expected, heating above the melting point of GMS (65 °C) facilitated the process and reduced the particle size of the dispersed phase. This step improved the gloss of the coatings. Superior properties were found with GMS types containing 40-50% monoglycerides (mono-and di-glycerides, NF or glycerol monostearate, DAB 10). As GMS stabilizes suspensions, the sedimentation of pigments was reduced. Being added in low quantities, the tenside formed more flexible films than conventional talc formulations do. Adjustments of the spraying process remained in agreement with usual Eudragit® technology. However, coating times were reduced because of higher polymer content in the spraying fluids. GMS did not effect physico-chemical properties such as permeability and solubility of the coatings. Thus, usual amounts of polymer were needed for controlled drug release. Sticking of coated particles could be prevented by applying 0.1 to 0.3% of GMS from an aqueous suspension with 2% solids. Storage stability of the formulations was proved over 2 years even under accelerated conditions. Disintegration properties of tablets and dissolution rate of the active ingredients varied within the analytical error of the methods. Thus GMS turned out to be an alternative to talc in coating suspensions, being more effective, less toxic and bearing less potential for incompatibilities.