20:T41b,Abstract Indoor photovoltaics are promising to enable self‐powered electronic devices for the Internet of Things. Here, reported is a triple‐anion CH 3 NH 3 PbI 2− x BrCl x perovskite film, of which the bandgap is specially designed for indoor light harvesting to achieve a record high efficiency of 36.2% with distinctive high open circuit voltage ( V oc ) of 1.028 V under standard 1000 lux fluorescent light. The involvement of both bromide and chloride suppresses the trap‐states and nonradiative recombination loss, exhibiting a remarkable ideality factor of 1.097. The introduction of chloride successfully restrains the halide segregation of iodide and bromide, stabilizing the triple‐anion perovskite film. The devices show an excellent long‐term performance, sustaining over 95% of original efficiency under continuous light soaking over 2000 h. These findings show the importance and potential of I/Br/Cl triple‐anion perovskite with tailored bandgap and suppressed trap‐states in stable and efficient indoor light recycling.21:T490,Perovskite solar cells are strong competitors for silicon-based ones, but suffer from poor long-term stability, for which the intrinsic stability of perovskite materials is of primary concern. Herein, we prepared a series of well-defined cesium-containing mixed cation and mixed halide perovskite single-crystal alloys, which enabled systematic investigations on their structural stabilities against light, heat, water, and oxygen. Two potential phase separation processes are evidenced for the alloys as the cesium content increases to 10% and/or bromide to 15%. Eventually, a highly stable new composition, (FAPbI₃)_0.9(MAPbBr₃)_0.05(CsPbBr₃)_0.05, emerges with a carrier lifetime of 16 μs. It remains stable during at least 10 000 h water-oxygen and 1000 h light stability tests, which is very promising for long-term stable devices with high efficiency. The mechanism for the enhanced stability is elucidated through detailed single-crystal structure analysis. Our work provides a single-crystal-based paradigm for stability investigation, leading to the discovery of stable new perovskite materials.22:T416,Minimizing surface defect is vital to further improve power conversion efficiency (PCE) and stability of inorganic perovskite solar cells (PSCs). Herein, we designed a passivator trifluoroacetamidine (TFA) to suppress CsPbI_3-x Br_x film defects. The amidine group of TFA can strongly chelate onto the perovskite surface to suppress the iodide vacancy, strengthened by additional hydrogen bonds. Moreover, three fluorine atoms allow strong intermolecular connection via intermolecular hydrogen bonds, thus constructing a robust shield against moisture. The TFA-treated PSCs exhibit remarkably suppressed recombination, yielding the record PCEs of 21.35 % and 17.21 % for 0.09 cm² and 1.0 cm² device areas, both of which are the highest for all-inorganic PSCs so far. The device also achieves a PCE of 39.78 % under indoor illumination, the highest for all-inorganic indoor photovoltaic devices. Furthermore, TFA greatly improves device ambient stability by preserving 93 % of the initial PCE after 960 h.

	Year	Citations

References