Materials · 2023 · 16 citations · 36 references
EngineeringManufacturing EngineeringMaterials EngineeringAdditive ManufacturingMaterials ProcessingMetallic MaterialsAlloysMetal Additive ManufacturingMetal FabricationMetalsMetalworking TechnologyThermal SprayingAbrasive Wear BehaviorAbrasive Wear ResistanceAccuracyAdditive Manufacturing MicrostructureAdditive Manufacturing Of Metal StructuresAdhesive StrengthMicrostructureSpray Technique
Cold Spray Additive Manufacturing (CSAM) is a thermal spray technique that is typically used for the repair of metallic components. One of the challenges of CSAM is to improve the geometrical accuracy of the sprayed parts, along with overcoming the inferiority of the mechanical properties of the deposits by tailoring their microstructure with different deposition strategies. For this, Cu, Al, Ti, and Ti6Al4V substrates were reconstructed by two Cold Spray (CS) methods: Traditional (T) and a novel strategy, Metal Knitting (MK). The final geometry, microstructure, and mechanical properties of the reconstructed parts by these two methods were compared. Additionally, we investigated the effects of annealing on the microstructure of sprayed components and its influence on adhesion, resistance to erosion, and abrasive wear. The results indicate that annealing effectively reduces the microstructure defects of the remanufactured parts (up to 30% porosity reduction) and improves the adhesive strength (i.e., below 30 MPa for as-sprayed deposits, and up to 160 MPa for heat-treated Ti4Al4V deposits). Notably, the abrasive and erosive resistance of the Cu and Al annealed deposits sprayed by MK gave very similar results compared to their bulk counterparts, suggesting that it is an efficient method for the reconstruction of damaged parts.
36
Additive manufacturing of metals
Dirk Herzog, Vanessa Seyda, Eric Wycisk et al. · Acta Materialia · 2016 · 4.6K citations · Full text
Engineering, Manufacturing Engineering, Materials Engineering +12
Development of a generalized parameter window for cold spray deposition
Tobias Schmidt, F. Gärtner, H. Assadi et al. · Acta Materialia · 2005 · 1.1K citations
Cold spraying – A materials perspective
H. Assadi, H. Kreye, F. Gärtner et al. · Acta Materialia · 2016 · 908 citations · Full text
Natural Sciences, Materials Engineering, Materials Science +11
General aspects of interface bonding in kinetic sprayed coatings
Gyuyeol Bae, Yuming Xiong, Santosh Kumar et al. · Acta Materialia · 2008 · 478 citations
Natural Sciences, Materials Engineering, Materials Science +16