Engineering Structures · 2022 · 94 citations · 46 references
EngineeringManufacturing EngineeringMaterials EngineeringAdditive ManufacturingMechanical Behavior Of MaterialsStructural MaterialsBeam AnalysisBeam TheoryBending Of BeamsDeflection Of BeamsDesign For Additive ManufacturingMetal Additive ManufacturingStress Distribution In BeamsWire Arc Additive ManufacturingWire Cross-section Geometry
Wire arc additive manufacturing (WAAM) is a promising metal 3D printing technique in the construction industry for its ability to produce large and complex-shaped elements, with reasonable printing accuracy, time and costs. There is currently, however, a lack of fundamental test data on the structural performance of WAAM elements. To address this, an experimental study into the cross-sectional behaviour of WAAM tubular beams has been conducted and is presented herein. A total of 14 stainless steel square, rectangular and irregular hollow sections, spanning over all cross-section classes of EN 1993-1-4 and AISC 370, were tested in four-point bending. 3D laser scanning, silicone casting and Archimedes’ measurements were employed to collectively determine the as-built geometry and local geometric imperfections of the test specimens, while digital image correlation (DIC) was used to monitor the deformation responses of the specimens during testing. The full moment–curvature histories and key experimental results are presented and discussed. Similar cross-sectional behaviour to that of equivalent, conventionally manufactured sections was observed, with the more slender cross-sections showing increased susceptibility to local buckling. However, owing to the inherent geometric variability of WAAM, the tested 3D printed beams exhibited more variable flexural capacities between the repeat specimens than is generally displayed by conventionally produced stainless steel sections. Finally, the test results were used to assess the applicability of current cross-section design provisions in the European (EN 1993-1-4) and American (AISC 370) structural design specifications, as well as the continuous strength method (CSM), to WAAM stainless steel tubular beams.
46
Donghong Ding, Zengxi Pan, Dominic Cuiuri et al. · The International Journal of Advanced Manufacturing Technology · 2015 · 1.6K citations
Engineering, Manufacturing Engineering, Materials Engineering +16
Developments in construction-scale additive manufacturing processes
Sungwoo Lim, Richard Buswell, Trung Thanh Le et al. · Automation in Construction · 2011 · 1.2K citations · Full text
Engineering, Civil Engineering, Manufacturing Engineering +12
Materials for additive manufacturing
David L. Bourell, Jean Pierre Kruth, Ming C. Leu et al. · CIRP Annals · 2017 · 1K citations