Effect of Na <sub>2</sub> O Doping on the Surface and Catalytic Properties of the Mn <sub>2</sub> O <sub>3</sub> /Al <sub>2</sub> O <sub>3</sub> System

G.A. El-Shobaky, A.M. Ghozza, S. M. Hammad

Adsorption Science & Technology · 1995 · 11 citations · 19 references

Concepts

Abstract

Manganese/aluminium mixed oxide solids having the formula 0.2MnCO 3 /Al 2 O 3 were prepared by mechanical mixing of a known weight of finely powdered manganese carbonate and aluminium hydroxide. The solids obtained were treated with NaNO 3 (0.75–6 mol%) solution and dried at 110°C, then calcined in air at 500°C and 800°C for 6 h. The phases produced were identified by XRD analysis. The surface properties (S BET , V p and r̄) of the pure and doped solids were studied by using N 2 adsorption at – 196°C and their catalytic activities were determined by studying the oxidation of CO by O 2 at 125–300°C. The results obtained reveal that pure and doped mixed solids preheated in air at 500°C and 800°C consist of Mn 2 O 3 (partridgite) and a poorly crystalline γ-alumina. Doping with sodium oxide at 500°C and 800°C resulted in a small decrease (14–19%) in the S BET value of the treated solids. However, this treatment brought about a significant modification in the catalytic activity of the doped solids. Doping with 0.75% Na 2 O at 500°C led to an increase of about 30–50% in the specific catalytic activity which was found to decrease on increasing the percentage of Na 2 O above this limit, falling to values smaller than that measured for the undoped catalyst. Doping at 800°C led to a progressive decrease in the activity of the treated solid to an extent proportional to the amount of dopant present. The doping process at 500°C and 800°C did not modify the mechanism of the catalytic reaction but altered the number of catalytically-active sites contributing in the catalysis of CO oxidation by O 2 without changing their energetic nature.

References

19