Proceedings of SPE/DOE Enhanced Oil Recovery Symposium · 1990 · 31 citations · 0 references
EngineeringPetroleum EngineeringReservoir EngineeringRock MechanicsSubsurface Fluid FlowFluid-flow In Porous MediaPorous MaterialsPorous Media FlowRock PermeabilityRock-fluid InteractionsTransport In Porous MediaAdsorption ModelingFlow Through Porous RockPolymer Concentration EffectsPolymer RetentionPolymer Solution Flow BehaviorPolymer Transport In Porous MediaPolymer-reservoir InteractionPorous Polymers
SPE Members *Now with Chevron Research Co.Abstract. Retention of a polymer in reservoir rock is examined theoretically and experimentally. In the theoretical part, a pore-level description of mechanical entrapment of a polymer in a model porous medium is developed, which shows that the porous medium is developed, which shows that the trapping rate is proportional to the flux of polymer, and decreases almost linearly with the amount polymer, and decreases almost linearly with the amount of trapped polymer until the maximum retention is reached. The maximum retention increases with increasing polymer concentration, and also with increasing flow velocity. The dynamics of polymer trapping indicates that if a polymer has a good solvency in water, it has less tendency to be trapped; but if a polymer has a high intramolecular permeability, it will have a high tendency for trapping. Based on the pore-level considerations, a phenomenological polymer retention model is proposed that accounts for both the adsorption of proposed that accounts for both the adsorption of polymer molecules on rock surfaces and the polymer molecules on rock surfaces and the mechanical entrapment in pore matrices. An analytical solution for flow of a single-phase polymer solution in a core is obtained to polymer solution in a core is obtained to interpret retention data from laboratory corefloods.In the experimental part, the retention of xanthan biopolymers from semi-dilute solutions flowing in a sandstone core is measured as a function of polymer concentration, flow velocity, and polymer concentration, flow velocity, and permeability of rock. The proposed retention model is permeability of rock. The proposed retention model is shown to adequately represent two characteristic features of typical polymer effluent profiles from corefloods, that is, the frontal delay and the gradual approach to feed concentration. Treating retention with adsorption alone generally fails to describe these features. The effects of dispersion and the commonly-encountered, high accumulation of polymer near the core face are also examined by analyzing the coreflood effluent data with a finite-difference numerical solution of the above linear flow problem.Introduction. The success of a micellar/polymer oil recovery process hinges not only on the effectiveness of process hinges not only on the effectiveness of the chemicals, but also on the ability to maintain mobility control. Awareness of the critical importance of mobility control has grown over recent years as results from field applications of these processes have accumulated. In most cases, the processes worked well near the injection wells. Oil was not displaced effectively however throughout the intended flooding volume. This poor performance could generally be attributed to a failure of the polymer to propagate over long distances and to the consequent loss of mobility control. A number of factors can cause poor polymer propagation. First, a large poor polymer propagation. First, a large retention of polymer in reservoir rock will erode the polymer bank, and prevent effective propagation. polymer bank, and prevent effective propagation. Second, the polymer can fail to transport if it is consumed by microbial degradation, or by chemical degradation in the presence of oxidants. These latter problems can usually be remedied by using an appropriate biocide or by eliminating oxidants from injected fluids. The first factor, retention of polymer in reservoir rock, is difficult to remedy and is the subject of this study.Although the poor transport of polymer was an unexpected result in field tests, some evidence for polymer retention as an important factor in mobility control loss on the field scale can be found by detailed examination of laboratory results available in the literature, and by consideration of possible retention mechanisms.P. 567