Journal of Manufacturing and Materials Processing · 2022 · 15 citations · 18 references
EngineeringMaterials EngineeringMaterials ScienceAdditive ManufacturingPolymer EngineeringPolymer MaterialsComposite MaterialsExtrusion ProcessingMaterial ExtrusionPolymer CompositesPolymer ExtrusionStrength Of MaterialsAnisotropy In Tensile PropertiesExtrusion Processing ParametersProcess ParametersProcess Parameters OptimizationSubstrate Temperature EffectsTensile StrengthTensile Strength TestingThermoplastic Composites
Large structural parts manufactured by Extrusion Additive Manufacturing (EAM) are limited by strong anisotropy due to insufficient bond formation and reduced molecular entanglement along the layer interface. To understand the correlation between process and material parameters and to enable digital modeling of EAM, the effect of different substrate temperatures and layer heights on tensile strength was investigated. A simple testing methodology for pelletized carbon fiber-filled polyamide 6 was developed. Tensile tests were performed in a full factorial Design of Experiments (DoE) to determine the tensile properties. For bulk simulation, the nominal strength and modulus were also determined based on contact width obtained by optical microscopy. The results demonstrated high anisotropy, with the maximum transverse tensile strength reaching only 27% of the corresponding longitudinal results and the transverse tensile modulus reaching only 20% of its longitudinal value. The effects of varying layer height were less significant than varying substrate temperature. The results support the hypothesis that sufficient transverse tensile strength is achieved between the extrapolated crystallization onset and melt temperature. The methodology of this study can be used as a benchmark method to qualify new thermoplastic polymers for EAM processes and to determine optimal process parameters for improved fusion bonding.
18
Anisotropic material properties of fused deposition modeling ABS
Sung‐Hoon Ahn, Michael Montero, Dan Odell et al. · Rapid Prototyping Journal · 2002 · 2.3K citations
Fuda Ning, Weilong Cong, Yingbin Hu et al. · Journal of Composite Materials · 2016 · 624 citations
Engineering, Manufacturing Engineering, Materials Engineering +17