Effect of the processing route on the microstructure and mechanical behavior of superlight Mg-9Li-1Zn alloy via friction stir processing

Abstract

In this study, the effect of the processing route using a friction stir processing (FSP) method on the microstructure and mechanical behavior of a Mg-9Li-1Zn alloy was systematically investigated. In the FSP method, the odd-numbered (1st and 3rd) process directions and even-numbered (2nd and 4th) passes were alternated to distribute the strain throughout the whole processed zone uniformly. Consequently, the processed zone had a much more uniform microstructure and hardness distribution than the processed zone obtained using the conventional FSP method. Using this method, the grain size of a Mg-9Li-1Zn sheet alloy was refined from ∼31 µm to ∼0.21 µm with uniformly distributed α and β phases. The processed alloy exhibited a high strength-ductility synergy with an ultimate tensile strength (UTS) of 220.1 MPa and total elongation of 70.0% at a strain rate of 10−3 s − 1, overwhelmingly higher than those of the base metal, 155.6 MPa in UTS and 36.0% in elongation. The in-situ SEM-DIC analysis and TEM observation demonstrated that such an outstanding ductility with moderate strength is caused by grain boundary sliding, the dominant deformation mechanism of the ultra-fine-grained sample after FSP. The processing route with reverse processing direction was proven to be efficient in producing the ultrafine grain size microstructure and improving the mechanical properties of superlight Mg-9Li-1Zn alloy.