Russian Journal of Nondestructive Testing · 2021 · 15 citations · 18 references
EngineeringMaterials EngineeringMaterials ScienceFinite Element AnalysisMechanical Behavior Of MaterialsUltrasoundMetalworking TechnologyResidual StressUltrasonic WeldingUltrasonicsWeldingWelding ProcessesAluminum Alloy WeldingExperimental Study DesignResidual Stress EvaluationResidual Stress In Welded JointsResidual Stress PredictionResidual Stresses In WeldsWeld-induced Residual StressWelding Residual Stress
Nowadays, measuring residual stress in welded parts is of great importance in the industry. Based on the measured residual stress and the operational conditions of the part, a suitable factor of safety is defined for the design. Destructive methods have most often been used to determine residual stresses. Given limitations such as high cost, non-destructive testing (NDT) methods have replaced destructive methods in recent years. The ultrasonic method has attracted much attention in recent years for determining residual stress. In addition to its simplicity, low cost, and the need for only a few pieces of equipment, this method has additional advantages such as the ability to measure residual stress at various depths. In this paper, the feasibility of the ultrasonic method in measuring residual stress in the fusion welding of two aluminum sheets was studied and compared with the simulation result. The longitudinal residual stress was measured using the ultrasonic method via 1, 2, 4, and 5 MHz transducers at a depth near the surface. An ultrasonic wedge based on Snell’s equation was built to create the LCR wave and transmit it into the part. Next, the results obtained from the ultrasonic measurement were compared with those obtained through the numerical simulation in Abaqus software. Overall, it was found that the ultrasonic simulation method could predict with high accuracy the residual stress at various depths of the part. Furthermore, the results demonstrated that the accuracy of this method declined with an increase in the ultrasonic frequency.
18
Finite Deformations of an Elastic Solid
F. D. Murnaghan · American Journal of Mathematics · 1937 · 1.4K citations
Second-Order Elastic Deformation of Solids
D.S. Hughes, J. L. Kelly · Physical Review · 1953 · 1.1K citations
Natural Sciences, Materials Engineering, Materials Science +17
Methods of measuring residual stresses in components
N.S. Rossini, Michele Dassisti, K.Y. Benyounis et al. · Materials & Design (1980-2015) · 2011 · 903 citations · Full text
Natural Sciences, Materials Engineering, Materials Science +12