Materials and Structures · 2021 · 22 citations · 43 references
EngineeringMaterials EngineeringMaterials ScienceAdditive ManufacturingMechanical Behavior Of MaterialsStructural MaterialsCementitious MaterialsMaterial ExtrusionCement ChemistryCement HydrationHydration KineticsIn Situ X-ray DiffractionInduction PeriodMaterial Stability AssessmentP-wave Velocity AnalysisWorkability
Abstract Extrusion-based additive manufacturing imposes high requirements on the material stability right after the extrusion. Therefore, a thorough understanding of the chemical reactions that determine the early reduction in processability is necessary. Accelerators are especially considered here, which have a major influence on the early reaction. This study contributes to these issues by analyzing the influence of 0.1 wt% TEA (triethanolamine) and 2.0 wt% Ca(NO 3 ) 2 on the hydration of two CEM I 52.5 R. The hydration was analyzed by isothermal heat flow calorimetry and in-situ X-ray diffraction. Vicat needle penetration, a penetrometer of own design, and ultrasonic P-wave velocity development were used to monitor the early change in workability. The obtained results indicate that ettringite formation is the main factor influencing workability during the first 60 min of hydration. Afterwards, the influence of ettringite is exceeded by the formation of C–S–H. Ca(NO 3 ) 2 was shown to enhance C–S–H formation and had no significant effect on the workability during the first 60 min of hydration while rapidly decreasing workability during the induction period. TEA was shown to increase brownmillerite dissolution and ettringite formation and, consequently, promote the workability loss during the initial hydration period. The time of initial and final setting determined by the Vicat needle test depended mainly on the formation of C–S–H phases.
43
Mechanisms of cement hydration
Jeffrey W. Bullard, Hamlin M. Jennings, Richard A. Livingston et al. · Cement and Concrete Research · 2010 · 2.1K citations · Full text
Mix design and fresh properties for high-performance printing concrete
Tuan Trung Le, Simon A. Austin, Sungwoo Lim et al. · Materials and Structures · 2012 · 1.2K citations · Full text
Developments in construction-scale additive manufacturing processes
Sungwoo Lim, Richard Buswell, Trung Thanh Le et al. · Automation in Construction · 2011 · 1.2K citations · Full text
Engineering, Civil Engineering, Manufacturing Engineering +12
The origins of thixotropy of fresh cement pastes
Nicolas Roussel, Guillaume Ovarlez, Sandrine Garrault et al. · Cement and Concrete Research · 2011 · 925 citations · Full text