Publication | Open Access
Influence of Stoichiometry and Aging at Operating Temperature on Thermoelectric Higher Manganese Silicides
24
Citations
24
References
2020
Year
Magnetic PropertiesEngineeringPower Factor DropThermoelectricsSolid-state ChemistryChemistryInorganic MaterialThermal ConductivityThermodynamicsD Superspace ApproachAccepted Phase DiagramThermoanalytical MethodMaterials ScienceOperating TemperaturePyroelectricityCrystallographyMicrostructureHigh Temperature MaterialsSinteringApplied PhysicsThermoelectric MaterialThermal EngineeringFunctional MaterialsThermal Property
Thermoelectric higher manganese silicides, MnSix, were synthesized by magnesioreduction followed by spark plasma sintering with different nominal compositions (x = 1.65, 1.74, and 1.80) and various postsynthesis annealing durations (0, 48, 96, and 336 h). The composite Nowotny chimney-ladder crystal structures of the resulting samples were investigated by synchrotron X-ray powder diffraction. The modulation vector component γ, generally considered corresponding to the stoichiometry (x) of the material, was accurately determined by Rietveld refinement using a (3 + 1)D superspace approach. Regardless of the initial nominal composition, all the samples have a similar γ ∼ 1.736 after 48 h of annealing at 900 K. This result suggests that MnSix, at a temperature of 900 K, is better described as a defined compound with x close to 1.736, rather than intermediate solid-solution phases with 1.725 < x < 1.75 as predicted by the commonly accepted phase diagram. At the fixed nominal composition MnSi1.74, γ increases significantly from 1.7313(2) to 1.7411(1) after 336 h of annealing, indicating that the thermal history influences the Si stoichiometry. The evolution of γ with time is concomitant with a power factor drop (−19%), attributed to a decrease in charge carrier concentration. The drop of the power factor, partially compensated by a decrease in thermal conductivity, results in a −12% reduction of the maximum figure-of-merit ZT, after prolonged annealing under realistic application conditions.
| Year | Citations | |
|---|---|---|
Page 1
Page 1