MANUFACTURING TECHNOLOGY · 2014 · 19 citations · 3 references
EngineeringMaterials EngineeringMaterials ScienceMechanical Behavior Of MaterialsMetallurgySolidificationAlloy SolidificationAlloysCrystallization ProcessesSolidification MicrostructureSolidification Of MetalsSolidification ShrinkageAlloy Solidification MicrostructureEutectic Growth KineticsOptimum TemperaturePressure ApplicationSolidification ParametersSolidification Shrinkage EffectsSqueeze CastingTemperature Optimum
This study investigated the effects of squeeze parameters on the properties of squeeze castings and the optimum parameters for producing squeeze castings from Al-Si alloy. It also compared the properties of the squeeze castings with those of chill castings. Squeeze castings were made from AlSi7Mg0.3 alloy using pressures of 15-22.5-30MPa with the alloy poured at 680, 700, 720 and 740C into a die preheated to 150, 200 and 250C. Squeeze time was 10s. At the pressure effect during crystallization there is possible to observe the refinement of eutectic silicium with the increasing pressured. Eutectic Si is excreted in clusters in comparison with non-influenced structure. There comes to increasing of failure strength and mainly of elongation. The hardness of investigated samples was not changed markedly. At the pressure of 15 MPa there comes to inadequate pressure influence, what causes the creation of shrinkage in the longitudinal part of the sample. This decreases the mechanical properties.
3
Squeeze casting results of aluminium alloys
Iva Nová, Jiří Machuta · MANUFACTURING TECHNOLOGY · 2013 · 17 citations · Full text
Prediction of the Porosity of Al Alloys
Marek Brůna, Lukáš Kucharčík · MANUFACTURING TECHNOLOGY · 2013 · 15 citations · Full text
Influence of returning material on porosity of die castings
Ľ. Eperješi, Jozef Malík, Š. Eperješi et al. · MANUFACTURING TECHNOLOGY · 2013 · 15 citations · Full text