Cyclic Testing of Soil for Oeean Wave Loading Problems

Kermeth L. Lee, John A. Focht

Offshore Technology Conference · 1975 · 10 citations · 0 references

Concepts

Abstract

ABSTRACT Foundation design for offshore structures on soil requires a knowledge of the design storm wave time history and the corresponding strength of the soil subjected to cyclic stresses that simulate this design wave loading. Suggestions are given for a useful method of expressing the design storm loading, and of interpreting the strength data from cyclic tests on undisturbed samples of soil. INTRODUCTION Conventional geotechnical engineering practice requires that the soil strength be obtained by an appropriate laboratory test that simulates on a soil specimen the significant load and drainage time history which this element will feel in the field. This paper presents some of the procedures and thoughts pertaining to cyclic testing of soils for ocean wave loading problems developed by the writers over the past few years of involvement in foundation stability analyses, for both ocean wave and earthquake cyclic loading. Emphasis is placed on methodology rather than data. However, the form of the data curves that are used herein for illustration are based on actual data believed to be realistic, although in some cases not extensive. NATURE OF WAVE LOADING A 4-minute portion of an actual storm wave record16 is shown in Fig. 1. The impression conveyed by the record is that the wave heights are random, although the period is reasonably constant at about 12 seconds per cycle. Hydraulic model and analytical methods can be used to estimate forces on the structure caused by wave action such as this. Knowing the boundary forces, the wave-induced stresses in the foundation soil below the structure can also be calculated. These pulsating stresses will also be cyclic at approximately the same period as the waves, and for the purposes of the following discussion, can be considered roughly proportional to the wave heights. Thus ideally, to follow a true stress path method of analysis, a laboratory test on a typical soil specimen should follow a cyclic stress-time history similar to the irregular wave form of the design storm. Although technically feasible, this is presently not practical for at least the following two reasons:The most severe time history wave pattern is not known in; advance.Analytical methods are not presently able to use the results of such a sophisticated test efficiently. Instead, the most advanced techniques today (1975) use an intended " equivalent" uniform cyclic loading, sometimes coupled with static loading, to simulate the design irregular cyclic effect. The next obvious difficult question concerns how to define a uniform cyclic load to be equivalent to the random wave loading of an extended ocean storm. One possible approach might be to follow the lead of the oceanographic engineers who have coined the terms " significant wave" height and period. The significant wave is a probabilistic ideal and not. a real wave. It was first developed to be the average height estimated by observers of the largest 20 to 40 percent of the waves in a group.