Publication | Open Access
Fault seal modelling – the influence of fluid properties on fault sealing capacity in hydrocarbon and CO <sub>2</sub> systems
33
Citations
71
References
2020
Year
EngineeringContact Angle ValuesWater-rock InteractionEarth ScienceReservoir EngineeringDrillingPetroleum ReservoirFluid PropertiesPetroleum ProductionSystems EngineeringCo2 Miscible FloodingCarbon SequestrationContact AngleRock PropertiesFault SealCivil EngineeringNatural Gas Hydrate SystemFault Seal AnalysisGeomechanicsEnhanced Oil ProductionRock MechanicsPetroleum Engineering
Fault seal analysis is a key part of understanding the hydrocarbon trapping mechanisms in the petroleum industry. Fault seal research has also been expanded to CO 2 –brine systems for the application to carbon capture and storage (CCS). The wetting properties of rock-forming minerals in the presence of hydrocarbons or CO 2 are a source of uncertainty in the calculations of capillary threshold pressure, which defines the fault sealing capacity. Here, we explore this uncertainty in a comparison study between two fault-sealed fields located in the Otway Basin, SE Australia. The Katnook Field in the Penola Trough is a methane field, while Boggy Creek in Port Campbell contains a high-CO 2 –methane mixture. Two industry standard fault seal modelling methods, one based on laboratory measurements of fault samples and the other based on a calibration of a global dataset of known sealing faults, are used to discuss their relative strengths and applicability to the CO 2 storage context. We identify a range of interfacial tensions and contact angle values in the hydrocarbon–water system under the conditions assumed by the second method. Based on this, the uncertainty related to the spread in fluid properties was determined to be 24% of the calculated threshold capillary pressure value. We propose a methodology of threshold capillary pressure conversion from hydrocarbons–brine to the CO 2 –brine system, using an input of appropriate interfacial tension and contact angle under reservoir conditions. The method can be used for any fluid system where fluid properties are defined by these two parameters. Supplementary material: (1) Fault seal modelling methods and calculations, and (2) hydrocarbon and CO 2 interfacial tensions and contact angle values collected in the literature are available at https://doi.org/10.6084/m9.figshare.c.4877049 This article is part of the Energy Geoscience Series available at https://www.lyellcollection.org/cc/energy-geoscience-series
| Year | Citations | |
|---|---|---|
Page 1
Page 1