Sensing and Bio-Sensing Research · 2020 · 46 citations · 33 references
EngineeringBioengineeringBiomedical EngineeringAnalytical ChemistryBiosensorsSensorsChemical SensorsElectrochemical BiosensorsElectrochemical SensorsMolecular SensorsPoint-of-care BiosensingPoint-of-care Diagnostic DevicesElectrochemical SensingElectrochemical TransductionLabel-free DetectionMolecularly Imprinted Polymer SensorsPaper-based Analytical DevicesPaper-based Diagnostic DevicesPaper-based SensorsPoint-of-care Biosensors
Over the last years, paper technology has been widely spread as a more affordable, sustainable and reliable support material to be incorporated in the design of point-of-care (POC) diagnostic devices. However, the single work employing a paper-based device for 3-nitrotyrosine (3-NT), a relevant biomarker for oxidative stress (OS) that is a major origin for many diseases, is incapable of reading successfully complex samples because every species that oxidizes before ~0.75 V will also contribute to the final response. Thus, the introduction of a selective element was made into this set-up by including a molecularly-imprinted polymer (MIP) tailored in-situ. Herein, a novel MIP for 3-NT was assembled directly on a paper platform, made conductive with carbon ink and suitable for an electrochemical transduction. The biomimetic material was produced by electropolymerization of phenol after optimizing several experimental parameters, such a scan-rate, number of cycles, range of potential applied, monomer and template concentrations. Under optimal conditions, the label-free sensor was able to respond to 3-NT from 500 nM to 1 mM, yielding a limit of detection of 22.3 nM. Finally, the applicability of the (bio)sensor was tested by performing calibration assays in human urine samples and a good performance was obtained in terms of sensitivity, selectivity and reproducibility. Overall, the attributes of the herein described sensing approach can be compared to a very limited number of other electrochemical devices, that are still using a conventional three electrode system, making this paper-sustained device the first electrochemical (bio)sensor with potential to become a portable and low-cost diagnostic tool for 3-NT. In general, the incorporation of molecular imprinting technology coupled to electrochemical transduction enabled the fabrication of suitable smart sensors for wide screening approaches.
33
José Muñoz, Raquel Montes, Mireia Baeza · TrAC Trends in Analytical Chemistry · 2017 · 145 citations
Natural Sciences, Materials Engineering, Materials Science +16