Dry reciprocating wear and frictional behaviour of B4C reinforced functionally graded and homogenous aluminium matrix composites

Abstract

A comparative study was drawn for evaluating mechanical and tribological properties between as-cast, heat treated (HT) Functionally Graded (FG) A359/10 wt% B4C and homogenous A359/6 wt% B4C composites (wt% equivalent to FGM outer zone, determined by chemical dissolution method) processed through horizontal centrifugal and gravity casting techniques respectively. Metallographic analysis confirmed decreasing gradation of reinforcement particles from outer to inner layers for as-cast FG composite, whereas even distribution of reinforcement was observed throughout for homogenous composite. Formation of fine alpha-spheroidized eutectic silicon was observed in HT composite. Comparative analysis carried out for mechanical properties of as-cast to HT composite confirmed an improvement of 37.9 % for outer layer of FG composite and 32.6 % for homogeneous composite in micro-hardness, while an improvement of 24.1 % for outer layer FG composite and 5.6 % for homogeneous composite was observed for tensile strength. Reciprocating wear analysis confirmed superior resistance to wear for outer zone of HT FG composite, with an increasing trend for wear rate and friction co-efficient under the effect of load and sliding distance. A decreasing trend was observed for wear rate and friction co-efficient as weight percentage of reinforcement increased. Worn morphological analysis confirmed predominant delamination wear mechanism for homogenous composites, whereas a combination of abrasive, adhesive and delamination wear was observed for FG composite.