Investigations on microstructural and texture evolution during recursive friction stir processing of aluminium 7075 alloy

G. Girish, V. Anandakrishnan

Materials Research Express · 2019 · 20 citations · 64 references

Concepts

Abstract

In this study, a sincere attempt has been made to investigate the microstructural and texture evolution of 7075-O alloy fabricated by recursive friction stir processing (RFSP) method using a square profiled pin. Tool rotational speed (TRS), traverse speed (TS) and the number of passes were the three factors identified for the study at three levels each. Tensile strength and microhardness were the two selected measurands for each set of experiments. Experimental runs were carried out as per Taguchi L 27 design and the corresponding optimum parameters were determined as 1150 rpm, 60 mm min −1 and 4 passes. To emphasize the effect of multiple passes over the evolution of microstructure, specimen fabricated at optimum TRS/TS combination (1150 rpm, 60 mm min −1 ) at all three levels of passes (2, 4 and 6) were analysed. OM investigation on optimum samples reveals the formation of defect-free stir zone and the fractographic analysis on the ruptured area of the tensile specimen using SEM reveals the brittle mode of fracture. Further investigation was performed using advanced characterization techniques like x-ray diffraction (XRD), transmission electron microscope (TEM), and electron back-scattered diffraction (EBSD). Microstructural features reveal the homogeneous distribution of ultra-fine grains and the dominance of CDRX mechanism in the microstructural evolution of the stir zone. The decrease in grain size over subsequent passes indicates that the multiple passes have significantly influenced the microstructural arrangement. TEM observations reveal the formation of sub-grains by dislocations and the presence of refined second phase particles in the grain boundary. Bulk-Texture analysis confirms the increase in the intensity of texture components due to multiple passes. The lower volume fraction of the Goss and Cube component depicts that the recrystallization is retarded in few regions due to pinning by finer precipitates leading to the formation of finer grains.

References

64