A low-power and high-sensitivity magnetic field sensor based on converse magnetoelectric effect

Abstract

Tremendous progress has been made in boosting the realization of magnetoelectric (ME) magnetometers based on the direct ME effect (DME) for bulk ME laminates. In this work, we studied the potential of an electrically driven bulk magnetic field sensor based on the converse ME effect (CME). Starting from a discussion about the dependence of the induced voltage from the pickup coil on coil parameters and the CME coupling process, we then experimentally measured the optimized bias field in the off resonance region and observed the double-peak phenomenon that occurred within the resonance window. More importantly, the optimization with respect to the sample's dimension, excitation voltage, and frequency was conducted to improve the sensing capability for low-frequency magnetic fields. It was experimentally found that a limit of detection (LoD) of ∼115 pT for a magnetic field of 10 Hz and ∼300 pT for a magnetic field of 1 Hz was achieved when exciting the ME laminate at 1 V without any bias field. In this case, the power consumption for the ME laminate is only 0.56 mW, which is much lower compared to tens of milliwatts (10–100 mW) for optically pumped or flux gate sensors (excluding the power consumption from the electronics) and also shows advantages over conventional ME magnetic field sensors based on DME with a current pump.