CINECA IRIS Institutial research information system (University of Pisa) · 2018 · 10 citations · 0 references
Open access
EngineeringNuclear EngineeringNuclear Fuel CycleNuclear Safety AnalysisRadioactive Waste ManagementFuel DepletionNuclear Fuel ChemistryNuclear Fuel MaterialsThorium Fuel CycleFuel Utilization In Thorium CyclesNuclear Power StationsThorium FuelThorium Fuel PerformanceThorium Fuel ReprocessingThorium Oxide FuelThorium-based FuelsUranium Oxide Fuel
The Nuclear Power Plants (NPP) constructed in the XX century, also called generation II \nreactors, are still in operation, most of them Light Water Reactors, but are being decommissioned. \nThese reactors have a low burn up (~30 MWD/kg U) and utilize UO2 as nuclear fuel and are \noperating in a Once Through Cycle (OTC); they use a very low energy content of the natural \nresources (~0,5%). To overcome economic and political and partly safety issues, since the end of \nlast century, and beginning of this century, the nuclear industry launched a new generation of \nevolutionary reactors, called Generation III, such as the Westinghouse AP 1000, and AREVA EPR. \nThese reactors still use uranium as primary source but have an increased burn up (~60 MWD/Kg \nU), which although increasing the utilization of the natural resources (up to 1%), still are not \nsignificant to be considered sustainable: if only uranium is used in an OTC, uranium will be \nexhausted in this century. To increase the utilization of natural resources, recycling of uranium and \nplutonium is already in use in many countries and used as Mixed Oxide of U-Pu fuel (MOX) in the \nsame thermal reactors. To turn nuclear energy sustainable, a long-term deployment of innovative \nreactors is underway. These reactors and their associated fuel cycle are old concepts with \ntechnological improvements and generically denominated as Generation IV, are in development \nand, in some cases, they are breeders, HLW burners, and efficient concepts. Another concept that \nalthough not new is constitute by the Small Modular Reactors (SMR), with power less than 300 \nMWe, which nowadays are deserving a lot of attention by the nuclear industry. Another option is to \nutilize thorium as a primary source of energy. Although not fissile at thermal energy, it produces \n233U, which is one of best fissile nuclide (number of neutrons produced per neutron absorbed). Also, \nit is three times more abundant than uranium in the earth crust and has thermal physics properties \nwhen used as (U-Th) O2 better than UO2. Several Th/U fuel cycles, using thermal and fast reactors \nwere proposed and are still under investigation. Although, the first reactors to utilize thorium were \nPWR, using (U-Th)O2, such as the Indian Point, and Shipping Port, thorium has been proposed as \nfuel for the molten salt reactor, the advanced heavy water reactor, High Temperature Reactors, \nPebble Bed reactor, fast breeder reactors, and more recently, for the innovative accelerator driven \nsystem in a double strata fuel cycle and for the Generation IV, such as the LFTR - Liquid Fluoride \nThorium Reactor, which is a self-sustainable Molten Salt Reactor, promising to turn nuclear energy \nby fission in a sustainable source, with a utilization of the natural resources of 100%. This paper, \nbesides an introduction of the present time uranium fuel cycles, will give an over view of the \nthorium utilization in nuclear reactors and fuel cycles, with an emphasis in Advanced PWR.