Ammonia- hydrogen combustion in a swirl burner with reduction of NOx emissions

Najlaa Ali Hussein, Agustín Valera-Medina, Ali Safa Alsaegh

Energy Procedia · 2019 · 104 citations · 2 references

DOIFull text

Open access

Concepts

Abstract

Recently, ammonia is being considered for fuelling gas turbines as a new sustainable source. It can undergo thermal cracking producing nitrogen, hydrogen and unburned ammonia, thus enabling the use of these chemicals most efficiently for combustion purposes. Ammonia being carbon-free may allow the transition towards a hydrogen economy. However, one of the main constraints of this fuelling technique is that although the combustion of ammonia produces no CO 2 , there is a large NO x proportion of emissions using this fuel. In this work, cracked ammonia obtained from a modified combustion rig designed at Cardiff University was used to simulate a swirl burner under preheating conditions via heat exchangers. The primary objective of this system is to find new ways for the reduction of NO x emissions by injecting various amounts of ammonia/hydrogen at different mixtures downstream of the primary flame zone. The amount of injected ammonia/hydrogen mixture (X) taken from the thermal cracking system was ranged from 0%-4% (vol %) of the total available fuel in the system while the remaining gas (1.00-X) was then employed as primary fuel into the burner. CHEMKIN- PRO calculations were conducted by employing a novel chemical reaction code developed at Cardiff University to achieve the goal of this paper. The predictions were performed under low pressure and rich conditions with an equivalence ratio ϕ =1.2 in a swirl burner previously characterised at output powers of ~10 kW. Ammonia and hydrogen blends were evaluated from 50% NH 3 (vol %) with the remaining gas as hydrogen, continuing in steps of 10% (vol %) NH 3 increments. Results showed that the minimum unburned ammonia and higher flame temperature were achieved at 60%-40% NH 3 -H 2 when compared to other blends but with high NO emissions. These NO levels were reduced by injecting a small amount of NH 3 /H 2 mixture (X=4 %) downstream the primary zone in a generated circulations promoted by the new design of the burner which affecting the residence time hence reducing the NO emission in the exhaust gas.

References

2