IEEE Transactions on Microwave Theory and Techniques · 2019 · 39 citations · 37 references
EngineeringElectrical EngineeringLow-power DesignMicroelectronicsVlsi DesignCmos Circuit DesignHigh-frequency Semiconductor DevicesMicrowave Integrated CircuitsMicrowave OscillatorsMixed-signal Integrated Circuit DesignRadio-frequency Integrated CircuitsCmos OscillatorsLow-noise DesignMillimeter-wave Integrated CircuitsMode Switching StrategyPhase-locked LoopsRf Cmos DesignSilicon-on-insulator CmosSilicon-on-insulator Technology
This paper presents a millimeter-wave (mm-wave) phase-locked loop (PLL), with an output frequency centered at 54.65 GHz. It demonstrates a mode-switching architecture that considerably improves the lock time, by seamlessly switching between a low-noise mode and a fast-locking mode that is only used during settling. The improvement is used to counteract the increased lock-time caused by cycle-slips that results from using a high reference frequency of 2280 MHz, which is several hundred times the loop bandwidth. Such a reference frequency alleviates the noise requirements on the PLL and is readily available in 5G systems, from the radio frequency PLL. The mmwave PLL is implemented in a low-power 28-nm fully depleted silicon-on-insulator CMOS process, and its active area is just 0.19 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> . The PLL also features a novel double injection-locked divide-by-3 circuit and a charge-pump mismatch compensation scheme, resulting in state-of-the-art power consumption, and jitter performance in the low-noise mode. In this mode, the inband phase noise is between -93 and -96 dBc/Hz across the tuning range, and the integrated jitter is between 176 and 212 fs. The total power consumption of the mm-wave PLL is only 10.1 mW, resulting in a best-case PLL figure-of-merit (FOM) of -245 dB. The lock time in low-noise mode is up to 12 μs, which is improved to 3 μs by switching to the fast-locking mode, at the temporary expense of a power consumption increase to 15.1 mW, an integrated jitter increase to between 245 and 433 fs, and an FOM increase to between -235 and -240 dB.
37
High-speed CMOS circuit technique
Jiren Yuan, C. Svensson · IEEE Journal of Solid-State Circuits · 1989 · 792 citations
Engineering, Computer Engineering, Electrical Engineering +16