International Journal of Low-Carbon Technologies · 2017 · 37 citations · 34 references
Natural SciencesComputational EngineeringComputational Fluid DynamicsFluid DynamicsHeat TransferCompressible FlowComputational AerodynamicsTurbulenceTurbulent FlowCfd ValidationCompressible Navier-stokes EquationsComputational Fluid Dynamics ValidationOperating ConditionsTurbulence Closure ModelsTurbulence Modelling
Computational fluid dynamic tools have been widely used for the design and improvement of ejectors for cooling and other engineering applications over the last two decades. Most published works are based on the solution of the compressible RANS equations using commercially available codes. These codes provide a number of different turbulence models; however, very little information is available on which of these models are the most adequate to simulate ejector flow. Thus, the primary objective of this work is to assist researchers in the selection of a suitable turbulence model for the assessment of ejector cooling systems. Six turbulence models (standard k-, RNG k-, Realisable k-, standard k-, SST k- and Transition SST) are evaluated by comparing global performance indicators (coefficient of performance (COP) and critical back pressure) to experimental data obtained under a relatively wide range of operating conditions. Results clearly indicate that the Transition SST model predicts more accurately both the COP and the critical back pressure, with an average relative error of 4 and 1.4%, respectively, while the standard k- performs the poorest. By changing the model constants, from default to previously published values, in the standard k- model significantly improves COP predictions, only when the ejector operates in double-choking mode.
34
A 1-D analysis of ejector performance
Bin‐Juine Huang, Jan-Shun Chang, Cheng Wang et al. · International Journal of Refrigeration · 1999 · 1K citations
Thanarath Sriveerakul, Satha Aphornratana, K. Chunnanond · International Journal of Thermal Sciences · 2006 · 374 citations
Engineering, Computational Engineering, Mechanical Engineering +10