Proceedings of the 12th International Technical Meeting of the Satellite Division of The Institute of Navigation (ION GPS 1999) · 1999 · 16 citations · 0 references
EngineeringElectrical EngineeringAntennasGlobal Navigation Satellite SystemsPropagationAntenna MeasurementMultipath MitigationMultipath PropagationAttitude MeasurementsCarrier Phase CorrectionsCarrier Phase MeasurementCarrier Phase Multipath MitigationCarrier Phase ObservablesGain PatternMultipath EstimationPhase Correction
A process was developed to use the GPS signal to noise ratio (SNR) to identify an effective reflector for a given antenna. This is termed an effective reflector because the reflector identified can account for a number of effects found in the signal, including such things as multiple reflectors, changes in reflectivity, and changes in signal phase upon reflection. A physical location is used simply as a means to represent the spatial correlation of the multipath. Once a effective reflector location has been found, a carrier phase correction profile is computed for that reflector. The measured carrier phase is then corrected by that amount and a new attitude solution is computed. Using this technique, results from ground tests show that the RMS differential phase residuals improved from 11.37 mm to 8.56 mm, corresponding to a 25% improvement. These results were found using only a batch estimator to identify an effective reflector. For the CRISTA-SPAS flight data the lack of knowledge of the antenna gain pattern limited the ability of the method to determine a reliable reflector solution. Some residual improvement was found for the data. One such pass had a residual improvement from 6.4 mm to 5.5 mm. However, for much of the data, an effective reflector that improved the phase residuals could not be identified.