Fusion Technology · 1997 · 14 citations · 19 references
Natural SciencesChemical EngineeringChemistryInorganic ChemistryNuclear ChemistryNuclear Fuel CycleFuel DepletionIsotope SeparationGas FlowHelium Leak TestingHydrogen Isotope CompositionHydrogen Isotope RatiosPalladium MembranesPermeate FluxTritium Isotope EffectTritium Permeation
The permeation of protium, deuterium, and an equimolar deuterium-tritium mixture through finger-type Pd-Ag permeators of various configurations operated either in/out or out/in has been compared in parametric studies. The parameters included the permeate pressures; the feed-and-bleed flow rates; and the feed-gas composition, i.e., helium, Q2, and CQ4 (Q-hydrogen, deuterium, tritium). Results on the dependence of the hydrogen isotope breakthrough into the bleed-gas stream and thus on hydrogen isotope decontamination factors were obtained as a function of feed-gas flow. The observed isotopic effects are large, i.e., H2/D2 = 1.72 ± 0.03 and H2/DT = 2.06 ± 0.03. No evidence of permeator deterioration was observed after 1.5 yr of discontinuous operation with hydrogen isotopes—mostly deuterium-tritide. In situ evidence on the integrity of a Pd-Ag permeator was obtained from empirical permeation curves, helium leak measurements, and hydrogen isotope breakthrough curves. Methane poisons Pd-Ag slowly but progressively at 360°C. When the hydrogens in methane are replaced by tritium, the rate of poisoning considerably increases, and after a few days, the overall poisoning becomes severe. The poisoning by hydrocarbons can be completely reversed by heat treatment in laboratory air.
19
Fuel Clean-Up System: Poisoning of Palladium-Silver Membranes by Gaseous Impurities
J. Chabot, J. Lecomte, C. Grumet et al. · Fusion Technology · 1988 · 87 citations
Interstitial carbon in palladium
S ZLEMECKI · Journal of Catalysis · 1985 · 81 citations