PubMed · 2003 · 31 citations · 0 references
DentistryMaterials ScienceRestorative DentistryDental MaterialsMechanical Behavior Of MaterialsSurface Properties Of Dental MaterialsFluoride TherapyFluoride UseFluoride-releasing MaterialsSurface HardnessCompomer RestorativesFluoride FoamSurface Hardness DevelopmentSurface Hardness EnhancementTopical Fluoride AgentsTopical Fluoride ApplicationTopical Fluoride TherapyTopical Fluoride Treatments
This study investigated the effects of professionally applied topical fluorides on the surface hardness of a composite (Spectrum TPH), a compomer (DyractAP) and a giomer (Reactmer). Thirty specimens of each material were fabricated and stored in distilled water at 37 degrees C for one week. These specimens were then randomly divided into five groups of six and treated for 36 hours at 37 degrees C with one of the following: distilled water (control), 1.23% acidulated phosphate fluoride (APF) foam, 0.9% neutral foam, 1.23% APF gel and 0.4% stannous fluoride gel. The treated specimens were subsequently subjected to microhardness testing (load = 500 gf; dwell time = 15 seconds). Results were analyzed using ANOVA/Scheffe's test (p<0.05). The effects of topical fluoride application on surface hardness was material dependent. For all materials, treatment with APF gel and foam significantly reduced surface hardness when compared to the control. KHN values after exposure to APF gel were consistently the lowest and ranged from 4.53 to 15.97. Control KHN values were higher, ranging from 32.88 to 47.47. The surface hardness of the compomer was also significantly reduced after exposure to neutral foam. Therefore, the use of professionally applied topical fluorides, especially APF gel and foam, may be detrimental to the long-term durability of composite-based restoratives.