Spin-Coated vs. Electrodeposited Mn Oxide Films as Water Oxidation Catalysts

Abstract

Manganese oxides (MnO_x), being active, inexpensive and low-toxicity materials, are considered promising water oxidation catalysts (WOCs). This work reports the preparation and the physico-chemical and electrochemical characterization of spin-coated (SC) films of commercial Mn₂O₃, Mn₃O₄ and MnO₂ powders. Spin coating consists of few preparation steps and employs green chemicals (<i>i.e.</i>, ethanol, acetic acid, polyethylene oxide and water). To the best of our knowledge, this is the first time SC has been used for the preparation of stable powder-based WOCs electrodes. For comparison, MnO_x films were also prepared by means of electrodeposition (ED) and tested under the same conditions, at neutral pH. Particular interest was given to α-Mn₂O₃-based films, since Mn (III) species play a crucial role in the electrocatalytic oxidation of water. To this end, MnO₂-based SC and ED films were calcined at 500 °C, in order to obtain the desired α-Mn₂O₃ crystalline phase. Electrochemical impedance spectroscopy (EIS) measurements were performed to study both electrode charge transport properties and electrode-electrolyte charge transfer kinetics. Long-term stability tests and oxygen/hydrogen evolution measurements were also made on the highest-performing samples and their faradaic efficiencies were quantified, with results higher than 95% for the Mn₂O₃ SC film, finally showing that the SC technique proposed here is a simple and reliable method to study the electrocatalytic behavior of pre-synthesized WOCs powders.