PubMed · 2011 · 54 citations · 0 references
DentistryDental Materials ScienceCavity PreparationDental MaterialsProsthodontic MaterialsCeramic RestorationsCrown MaterialsDental CementsLuting CementsTooth FormTooth Preparation DesignAnatomic Occlusal FormCeramic Crown SystemsCeramic Restoration Marginal FitInternal AdaptationLuting Cement SelectionStatistical Significance TestingZinc Phosphate CementZinc Phosphate Cementation
PURPOSE: To evaluate the influence of two different tooth preparation forms, two luting space settings and two cement types on the marginal and internal adaptation of all-ceramic crown copings produced using Cerec3 CAD/CAM system. MATERIALS AND METHODS: Forty working stone dies were made from two metal master casts (1. Tooth 36: with anatomic occlusal reduction, 2. Tooth 36: with flat occlusal reduction). Forty crown copings were milled using Vita In-Ceram 2000 YZ: 20 with an luting space settings of 0 = 100 microm and 20 with -50 = 50 microm. Copings were cemented using two cements (zinc phosphate cement, P21: Panavia21), then embedded and sectioned bucco-lingually and mesio-distally. Widths of marginal and internal gaps were measured using a light microscope at magnification of 40X. Data were submitted to one-way ANOVA, and statistical significance was set at p < 0.05. RESULTS: Copings with flat occlusal reduction and luting space settings of 100 pm had a better internal and marginal fit compared with copings with anatomic occlusal reduction and luting space settings of 50 microm, regardless of the cement used. P21 showed a significantly better fit compared with zinc phosphate cement. CONCLUSION: The presented Cerec3 CAD/CAM system can provide a marginal and internal adaptation which is comparable to that of conventional cast and conventional all-ceramic crowns.