Heat Transfer and Pressure Drop Characteristics of Dilute Alumina–Water Nanofluids in a Pipe at Different Power Inputs

Richa Saxena, D. Gangacharyulu, Vijaya Kumar Bulasara

Heat Transfer Engineering · 2016 · 32 citations · 45 references

Concepts

Abstract

This work addresses the effect of temperature on the thermophysical properties (i.e., density, viscosity, thermal conductivity, and specific heat capacity) of alumina–water nanofluid over a wide temperature range (25°C–75°C). Low concentrations (0–0.5% v/v) of alumina nanoparticles (40 nm size) in distilled water were used in this study. The pressure drop and the effective heat transfer coefficient of nanofluids were also estimated for different power inputs and at different flow rates corresponding to Reynolds numbers in the range of 1500–6000. The trends in variation of thermophysical properties of nanofluids with temperature were similar to that of water, owing to their low concentrations. However, the density, viscosity, and thermal conductivity of nanofluids increased, while the specific heat capacity decreased with increasing the nanoparticle concentration. The convective heat transfer coefficient of the nanofluid and the pressure drop along the test section increased with increasing the particle concentration and flow rate of nanofluid. Results showed that the heat transfer coefficient increases, while the pressure drop decreases slightly with increasing the power input. This is because of the fact that increasing power input to heater increases the bulk mean temperature of nanofluids, resulting in a decreased viscosity. The prepared nanofluids were found to be more effective under turbulent flow than in transition flow.

References

45