Brush seals in industrial gas turbines. I - Turbine section interstage sealing

S. Dinc, G. Reluzco, Norman Turnquist, James L. Lawen, O. Kerber, F. Brunner, G. Crum, A. Stuck, R. Cromer, Peter Marks,

34th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit · 1998 · 11 citations · 2 references

Concepts

Abstract

Brush seals have been used in aircraft engines for a number of years and are starting to find their way into industrial turbines. Improved seal performance offers substantial opportunities for increasing engine performance as reduced leakage leads to greater efficiency and power output. There are a number of seal locations on a gas turbine that have significant performance derivatives. These include the compressor discharge, bearing seals, turbine interstage packings, and the bucket tips. While the application of brush seals to industrial gas turbines is conceptually similar to that of aircraft engines, there are some important differences. These include larger diameters and thickness, larger tolerance bands, split casings with the accompanying ellipticity and segmented seals, fewer transient excursions, constant synchronous speed, no landing or maneuver loads, longer operating life requirements, and, in the case of field retrofitting, the robustness to withstand field installation. Brush seals have been designed for and installed in the GE E-Class turbine high-pressure packing (compressor discharge) middle bearing and interstage packing locations. A previous paper describes the development of the high pressure packing and bearing seals, now commercialized with a performance improvement of 1.3% in power and 0.7% in heat rate. This paper describes the development of the turbine interstage seal, where preliminary results indicate performance improvements of 0.7% in power and 0.2% in heat rate. The development included tribological tests, leakage tests, low hysterisis design features, secondary flow path modeling, and field tests.

References

2