The Measurement of Turbomachinery Stator-to-Drum Running Clearances

D. P. Davidson, Robert D. DeRose, Arthur J. Wennerstrom

Volume 1: Turbomachinery · 1983 · 10 citations · 0 references

Concepts

Abstract

The clearance between a compressor or turbine case and rotating blades or shrouds has been measured in a variety of ways over the years with varying degrees of accuracy. However, one critical clearance which has defied active measurement heretofore has been that between the tip of a cantilevered stator vane and an adjacent drum rotor. A significant number of turbomachines under development, representing many millions of dollars, have met an inglorious end through unanticipated rubs which were experienced in this area. The present paper describes how a device which was introduced by its manufacturer for conventional rotor tip or shroud clearance measurements was applied to measure stator-vane-to-drum clearance. The installation technique is explained, and the results of vane-to-drum measurements made with a research compressor are presented. Adaptations of the same technique should permit similar measurements to be made within a turbine, and possibly on rotating seals buried deep within a turbomachine.